This bulkhead fitting is unlike many others you've seen. It's an all in one piece design that makes installation a snap!
Why is this setup better than your standard bulkhead fitting?
-
All in one fitting design. No extra tape, fittings, spacers and headaches to worry about. No need to buy a Compression fitting for your pick up tube...it's already there! Install your valve on the other end and you're done.
-
Only requires a 3/4" hole instead of a 7/8" like others.
-
Absolutely no threads where bacteria loves to hang out and ruin you brew.
-
Machined from 316 stock and not cast. Very smooth finish.
Gasket has been used both inside and outside of vessel. If it can be done on your setup we recommend using the gasket on the outside, just make sure to keep it away from the burner as much as possible.
