This bulkhead fitting is unlike many others you've seen. It's an all in one piece design that makes installation a snap!
Why is this setup better than your standard bulkhead fitting?
-
All in one fitting design. No extra tape, fittings, spacers and headaches to worry about. No need to buy a Compression fitting for your pick up tube...it's already there! Install your valve on the other end and you're done.
-
Only requires a 3/4" hole instead of a 7/8" like others.
-
Absolutely no threads where bacteria loves to hang out and ruin you brew.
-
Machined from 316 stock and not cast. Very smooth finish.
-
Last but not least...It's cheaper than your standard setup!
Click on "Image Gallery" above for more images.
This item comes with
